Docs

The Kathaka Studiohandbook.

Practical chapters with steps, what you should see, and what to do when something goes wrong. The same handbook is built into the app and works offline.

Open the printable handbook

Documentation & product specification

English · 18 / 27

Backgrounds, perspective and poses

Perspective makes buildings and roads look real and deep. Lines go to a vanishing point, a spot far away. Kathaka Studio can draw guide lines for you, and it has 3D figures you can pose.

Draw with perspective guides

  1. Open Draw & Paint and choose Perspective & reference workspace.
  2. Pick a ruler under Perspective rulers and press Apply.
  3. Turn on Show perspective guides.
  4. Turn on Snap pen strokes so your lines follow the guides.

Keep reference pictures close

  1. In Reference board, add pictures you want to look at while you draw.

Pose a 3D figure

  1. Open Draw & Paint and choose 3D pose & scene staging.
  2. Under Character pose, move the joints to make the pose.
  3. Use Camera & framing to choose the view.
  4. Press Capture to put a picture of the pose on your panel.

Plan a room from above

  1. Open the Page menu and choose Floor-plan blocking · set & camera.
  2. Press New floor plan. Add walls with Wall (tap two ends), and doors, windows and furniture with their buttons.
  3. Choose your panel under Camera for this panel. Pick Camera, tap where the camera stands and drag to aim it.
  4. Add people with Figure. Set Eye height, Tilt and Lens width.
  5. Press Set page guide from camera. The perspective guide on the page now matches the room.

Trace perspective from a photo

  1. Put a reference photo on the page.
  2. Open the Production menu and choose Home print & finishing · zine, light, SFX, rights, then Photo perspective.
  3. Tap both ends of two edges that run the same way in the room. Trace two more pairs for a second or third vanishing point.
  4. Press Set perspective guide.

Keep the light on one side

  1. On the first page of a scene, open Home print & finishing and choose Light.
  2. Set Direction and Height, add a note, and press Save light key.
  3. Every panel in the scene shows an arrow pointing away from the light. Draw shadows on the far side.

Perspective rulers and reference boards

  1. Open Perspective & reference workspace.
  2. Choose a page and set the vanishing points or a saved ruler.
  3. Import reference cards and add notes or rights information.
  4. Pin a useful reference and draw with the appropriate guide active.

3D pose and scene staging

  1. Open 3D pose & scene staging and create a scene.
  2. Choose a pose and adjust the arrangement of the figures.
  3. Position the camera and lights, then inspect the preview.
  4. Capture the staged reference and use it while composing a panel.

Perspective, staging and floor-plan blocking

  1. Open Perspective & reference workspace to add vanishing guides and references. Use 3D pose & scene staging to arrange a pose and camera, then review its capture before placing it.
  2. In Floor-plan blocking, draw the set from above, place characters and set a camera for each panel. Compare camera direction across adjacent shots.
  3. Apply the intended guide or capture to the chosen panel as a reference. Keep the source editable and draw your final artwork on a separate layer.

What you should see

Guide lines appear on the page, or a picture of your pose is added as a new layer.

Good to know

The pose picture is only a guide. Draw your own lines over it.

If something goes wrong

If your lines jump in strange ways, turn off Snap pen strokes.